UTV Chat talk Forum Board Rhino Clones ODES UTVS HiSun Massimo Motor Bennche Qlink Linhai Supermach USTitan 700cc UTV Cheap 500cc UTV Wholesale
Results 1 to 3 of 3

Thread: Linhai Bighorn 28 400cc stuck in 4wd

  1. #1
    Newbie
    Join Date
    Sep 2013
    Posts
    2
    Post Thanks / Like

    Linhai Bighorn 28 400cc stuck in 4wd

    As the title states my Linhai Bighorn is stuck in 4wd. I read another post with the same issue but never got a reply. So the indicator on the dash reads 4wd. All 4 wheels are pulling. If you put the 2/4wd selector in 4wd position, after about 30 seconds a low beeping starts and continues until I put it back in the 2wd position. Does anyone have any ideas?

    This just started after I replaced the CDI. I re-installed the old CDI long enough to see if it made a difference. It did not.

  2. #2
    Senior Member
    Join Date
    Feb 2011
    Posts
    115
    Post Thanks / Like
    I had this same problem on my Bighorn 300 when I 1st purchased. Turned out to be a bad selector module that is mounted on top of my front diff.
    I'm not sure if this will help you on your 400 but it's a start. You can PM me if you like, I have contacts and some parts that might help you.

    Good Luck,

    Sangair

  3. #3
    Newbie UTVMiser's Avatar
    Join Date
    Oct 2013
    Location
    Central FL
    Posts
    16
    Post Thanks / Like
    Here's the solution to my stuck in 4wd BMX Gorilla.

    Good luck

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •